Then a pin mm is inserted through one side of upper, through the lower and out of the other side of the upper. Once you have the bottom part inserted into the tab of the upperpart, then push the bottom towards the upper until it touches. Once the bolt has been completely tightened, you can fold the stock under the receiver. Once hand tightened, you need a allen/hex bit or driver to completely tighten the stock. You need to keep pressure on the retainer nut, while you screw in the bolt. You now take the stock and align it with the back of the receiver and you can insert the bolt and screw through the hole at the back of the receiver into the retainer bolt. You put the retainer inside the upper receiver and it will stick out a little bit. Look at the back of the Uzi upper receiver. You may have to use a wooden stock with this gun, depending on gun laws in your state. There several types of metal and wooden stocks available. ![]() The round part of the retainer nut, hangs out the back of upper receiver. Because the retaining bolt sits behind bolt and buffer block. The stock needs to be installed now before you install the bolt. Install the Folding Stock and Retaining Bolt. See Parts 1 through 4 for the steps that need to be done, before you finish the build in this post.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |